Featured Products
Featured Products
Special Products
Special Products
M103 Twin-scroll exhaust...
OM603 Twin-scroll exhaust...
OM606 Twin-scroll exhaust...
Active filters
-
3.0L M104
€3,300.00THIS KIT DOES NOT INCLUDE ANY ELECTRONICS
Everyone has different preferences on what ECU platform to use. Our hardware is suited for short EV14 Bosch injectors with 38mm adapters and Audi R8 Coils (AUDI OEM 06E 905 115 F)
Flow-tested injectors and adapters can be found on FINJECTORThere are some differences in engine models and this is a large package to ship so it's best if you place order for a kit through email info@turbobandit.com for personalized offer if for example you want to go with Garrett, Holset or BorgWarner turbina. Check below for kit contents.
-
2.8L/3.2L M104
€4,100.00THIS KIT DOES NOT INCLUDE ANY ELECTRONICS
Everyone has different preferences on what ECU platform to use. Our hardware is suited for short EV14 Bosch injectors with 38mm adapters and Audi R8 Coils (AUDI OEM 06E 905 115 F)
Flow-tested injectors and adapters can be found on FINJECTORThere are some differences in engine models and this is a large package to ship so it's best if you place order for a kit through email info@turbobandit.com for personalized offer if for example you want to go with Garrett, Holset or BorgWarner turbina. Check below for kit contents.
-
- On sale!
143mm for 3.0/3.2L M104.980 / M104.992 /M104.995 /M103.98X
€854.00Set of 6
Compression ratio: M103.98X from 9.2 to 7.8 M104.98X from 10 to 8.6 M104.99X from 10 to 8.5
Good for 1800hp, Bolts are included in all connecting rods!
Torque of oiled con-rod bolts: 3/8 "(9.53 mm) = 62 Nm
C / C: 143
Big End: 51.6
Pin: 22
Wide: 22
150g lighter then OEM rods! (each rod)
Note that some m104 older pistons has longer lower skirt and needs to be ground a bit so that the pistons do not rub the crankshaft
-
- On sale!
144mm for 3.0/3.2L M104.980 / M104.992 /M104.995 /M103.98X
€854.00Set of 6
Compression ratio: M103.98X from 9.2 to 8.5 M104.98X from 10 to 9.2 M104.99X from 10 to 9.1
Good for 1800hp, Bolts are included in all connecting rods!
Torque of oiled con-rod bolts: 3/8 "(9.53 mm) = 62 Nm
C / C: 144
Big End: 51.6
Pin: 22
Wide: 22
150g lighter then OEM rods! (each rod)
Note that some m104 older pistons has longer lower skirt and needs to be ground a bit so that the pistons do not rub the crankshaft
-
- On sale!
1300hp fuel system Mercedes w124 stock replacement kit
€1,049.201300hp fuel system (5009)
- 2x turbobandit fuelpumps
- 1x double fuelpump bracket
- 2x fuelpump fuel rail
- 1x an10 fuelfeed line 430cm
- 1x an8 fuelreturn line 270cm
- 1x an10 line between fuelfilter and fuelrail 100cm
- 1x an8 line between fuelrail and fuel pressure regulator
- 1x fuelfilter 100 micron (e85)
- 1x Fuel pressure regulator BIG ball focker
-
- On sale!
-
- On sale!
Basic fuel kit
€231.80 -
- On sale!
Fuelpump TURBOBANDIT
€189.10- 3 bar = 410L / hr
- 5 bar = 350L / hr
- 7 bar = 310L / hr
CONNECTIONS:
M18 x 1.5 in M12 x 1.5 out
-
- On sale!
FPR REAL BIG BALL FOCKER!
€164.70- Linear 1:1 race fuel pressure regulator type Aeromotive.
- Resistant to all kinds of fuels
- AN8 connections.
- Capable of 2000HP ++
- Double IN connections that make it even work for V-engines.
- AN fittings included.
-
- On sale!
Fuel Filter 100 micron
€96.58Connection:
Internal thread 7 / 8NF14
Total length of the filter:
14cm / Diameter 16cm
100 Micron
-
- On sale!
-
M104 Bolt on engine harness
€646.60- 6 injectors 2200cc connectors
- 6 vag coil connectors
- 1 IAT connector
- 1 CLT connector
- 1 TPS connector
- 1 knock sensor connector
- 1 VR sensor connector
-
M103 Bolt on engine harness
€585.60- 6 injectors 2200cc connectors
- 6 Wasted spark coil connectors connectors
- 1 IAT connector
- 1 CLT connector
- 1 TPS connector
- 1 knock sensor connector
- 1 VR sensor connector
-
-
-
-
-
-
-
-
-
